Skip to main content

Shell UK sentenced over major oil release

Published by , Editor
World Pipelines,


The spill

On 10 August 2011, a quantity of oil was spotted on the sea surface in the vicinity of Shell’s Gannet F field, 180 km from Aberdeen, Scotland. The initially reported surface area of oil was identified by the stand-by vessel, and was approximately 4.5 km in length and 100 m in width.

The oil release was subsequently observed to be emanating from a subsea relief valve attached to the Gannet F pipeline bundle in the vicinity of the Gannet F towhead protection structure.

The oil release was secured on 19 August 2011 when the relief valves were manually isolated and closed by divers. Shell subsequently estimated to the Department for Energy and Climate Change (DECC) that a total of 218 t of oil was released to sea during the incident.

Health and safety

The Health and Safety Executive (HSE) and DECC carried out a joint investigation into the incident, which concluded that the 8 in. Gannet F oil production pipeline within the pipeline bundle had failed. As a result, crude oil entered the insulated area between the production pipeline and its sleeve and was ultimately released to sea through the relief valves. It concluded there was no significant environmental impact or any risk that anyone would be harmed.

HSE served two Improvement Notices (INs) relating to processes during the investigation following the pipeline failure, which Shell subsequently complied with.

Regulations

Shell UK Limited admitted breaching the Regulation 3A of the Offshore Petroleum Activities (Oil Pollution Prevention and Control) Regulations 2005 and Regulation 13 of the Pipelines Safety Regulations 1996, and has been fined a total of £22 500 at Aberdeen Sheriff Court.

Edited from source by Stephanie Roker

Read the article online at: https://www.worldpipelines.com/equipment-and-safety/26112015/shell-uk-sentenced-over-major-oil-release/

You might also like

 
 

Embed article link: (copy the HTML code below):